How to ensure the safety of lathe in the process of making automobile stamping parts?

2021-08-10 08:23:40

Automobile stamping parts are processed by punch. In the whole process, the operation of lathe equipment is very key. If it is not grasped properly, it will not only affect the forming quality of stamping parts, but also damage the equipment. The key is that the safety of staff can not be guaranteed. Therefore, the operation requirements of lathe equipment for stamping parts processing will be brought to you.

Firstly, when the lathe is in stamping operation, the operator must take corresponding protective measures; At the same time, we should also conduct a comprehensive inspection of the equipment, including the stability of various parts, the working condition of the lathe, the installation accuracy of parts, etc. If any problem is found during the inspection, it shall be handled in time to avoid more serious consequences.

In addition, in the manufacturing process of stamping parts, in addition to the active measuring equipment on the lathe, it is necessary to stop to measure the workpiece to ensure safety. These mentioned in the above small series need to be paid attention to during processing, and they are all for your safety.

If you carefully observe the produced automobile stamping parts, you will find that there are concave convex on the product surface, which affects the quality of the whole workpiece. To improve this situation, we must first find the root of the problem before we can formulate relevant solutions. Stamping manufacturers have also realized the seriousness of this problem, so they have begun to improve.

For the concave convex of stamping gold surface, most of them are caused by impurities attached to raw materials or stamping dies; Or in the stamping process, the die of auto parts is collided; The height of the raw material conveyor belt is not reasonably adjusted; Deformation of station tools, etc. These problems mentioned above may cause deformation and concave convex of stamping parts.

In addition to individual reasons, they will also deform the stamping parts. These concave convex stamping parts need to be treated differently and can not be applied to automobile parts. If possible, it should be repaired in time. If the deformation is serious, it can only be discarded.