What is the difference between metal die and automobile stamping die?

2019-09-10 09:00:54

For automobile stamping parts, because they are website products and keywords, so the learning requirements are comprehensive and specific. Therefore, its knowledge content and related difficult problems should be involved, and none of them can be omitted. So, based on this, the following will proceed immediately to improve everyone's learning efficiency.

1. What is FLUSH in the measurement of automobile stamping parts? In addition, which parts of the car are required to have four-step stamping process?

If automobile stamping parts are inspected, then FLUSH, which is used in the measurement of automobile stamping fixtures, is interpreted as homogeneous plane inspection. In automotive parts, there are four-step stamping process, which is for some large panels, and they are also automotive stamping parts.

2. Is there any difference between stamping die and metal stamping die in automobile stamping parts?

If the stamping die in automobile stamping parts is compared with the metal stamping die, then the two are different, because for the former, there are many technical requirements of A side, and for the latter, there is no such requirement, so this conclusion can be drawn. So the main difference between the two is the technical requirements.

3. What are the specific requirements for automotive stamping parts in terms of raw materials?

The specific requirements of automobile stamping parts on raw materials are as follows:

The raw materials of stamping parts should have quality certification, and they should meet the relevant technical requirements, otherwise, they can not be used. In addition, some corresponding analysis or laboratory work can be carried out in order to check the material performance, whether there are defects, so as to determine whether it is available. In addition, if necessary, raw materials can also be re-examined to ensure that there is no mistake.